Operating - Bartscher 200.061 Mode D'emploi

You must not position the device near open fireplaces, electric ovens/arc furnaces,
•
furnaces/electric heaters or other heat sources.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
•
unit directly to the wall socket; do not use any extension cords or power strips.
Place the unit so that the plug is easily accessible and can be quickly removed from
•
its socket in case of necessity.

5.3 Operating

• Prior to first use, wash the unit with warm water and a mild cleaning agent. Rinse with
clean water and dry thoroughly.
• Fill the reservoir with the desired amount of fresh water (up to the marking „MAX").
CAUTION!
To reduce the time needed for heating, fill the reservoir with warm water. This will
save time and energy!
WARNING! Danger of burns!
Fill with only the necessary amount of water! Too much water in the reservoir may
result in spilling and burns!
• Place the lid on the reservoir using the lock, and turn the reservoir clockwise to close.
Connect the unit to an appropriate outlet. The green control light will come on.
•
CAUTION!
It is important that water be in the unit prior to turning it on. Do not will the
reservoir with other liquids which cannot be consumed, such as acids, alkalines,
oils, etc.!
• Set the desired temperature using the temperature dial between 30°C and 100°C.
When the temperature dial is turned, the red control light will come on and the green
light will go off.
• Water will be heated to the temperature set.
When the temperature set has been reached, the red control light will go off. The green
•
control light will come on, and the water will remain at a stable temperature.
WARNING! Danger of burns!
Never remove the lid when water is being boiled. Escaping steam can burn hands,
arms, and faces!
- 21 -