Charging The Battery - Royalty Line HVC-150.55R Mode D'emploi

1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the floor
nozzle installed.
2. Hold the wall holder against the wall as shown on page 3.
Mark 2 drill holes.
3. Drill the holes and insert the wall plugs into the wall.
4. Insert the screws through the holes of the wall holder.
5. Tighten the screws with a screwdriver hand-tight.

Charging the Battery

1. Turn off the device.
2. Connect the power supply unit with the connection socket
(5). If you have prepared the wall holder as a charging
station, suspend the appliance from the wall holder.
3. Connect the mains adapter to a certified wall socket.
Charge the device for approx. 5 hours before first-time use.
NOTE:
● The LED charge indication shows the charging status
of the rechargeable battery. (25 %, 50 %, 100 %)
● The appliance has electronic charge control, which
prevents overcharging.
● Charging has been completed when all 3 LEDs are lit.
● The LEDs go out after a while.
● It is normal for the device to heat up during charging.
4. The rechargeable battery must be charged when the LED
charge indication shows only 25 % of capacity.
5. Disconnect the power supply unit from the outlet once the
rechargeable battery has been charged completely.
NOTE:
Even when switched off, the rechargeable battery discharges
continuously. If the device is out of use for a longer period of
time, charge the rechargeable battery at least once every
6 to 12 weeks.