Nozzle Attachments - Royalty Line HVC-150.55R Mode D'emploi

● Slip the lower end of the suction pipe onto the connector on
the fl oor nozzle. Pay attention to the contact pin. The
suction pipe must audibly engage.
● To release the suction pipe, push the release (11) away from
the suction pipe and pull out the pipe at the same time.

Nozzle Attachments (16)

You can attach these two nozzle attachments directly to the
hand unit or to the already installed suction pipe.
Connection at the Hand Unit
● Insert a nozzle attachment with the marking facing up into
the connection at the hand unit. It must audibly engage.
● To disconnect the nozzle attachment, press the release
(14) and pull out the attachment at the same time.
Connection to the Suction Pipe
You need the adapter (15) for connection to the suction pipe.
● Insert the adapter with the angular side into the lower end
of the suction pipe.
● Now you can slip a nozzle attachment onto the round side
of the adapter.
● For removal of the nozzle attachment and the adapter,
just pull the parts off.
Combined Crevice / Brush Nozzle
With this nozzle, you can selectively vacuum corners and slots.
Use the nozzle with locked brush to prevent scratching of the
surface to be cleaned.
● For this, press the button
brush to the end of the nozzle. It must engage.
● Press the button again to unlock the brush.
and push the