Care And Cleaning; What To Do If Repairs Are Needed; Specifications And Accessories - Sanyo EM-C1800K Mode D'emploi

CARE AND CLEANING

ALWAYS KEEP THE OVEN CLEAN
1. Cleaning the glass viewing window, the inner door panel and oven
front face.
For best performance and to maintain the high degree of safety
the inner door panel and oven front face should be free of food or
grease build-up.
Wipe these parts with a mild detergent, rinse and wipe dry.
Never use abrasive powders or pads.
2. Cleaning the oven interior.
After use be sure to clean up spilled liquids, spattered oil and food
debris as quickly as possible. If the oven is used when dirty,
efficiency drops and the dirt gets stuck on the oven surface and
may cause bad odours. Clean the interior with a cloth soaked in
luke-warm water with a mild detergent dissolved in it, then rinse
the soap off with a damp cloth.
In particular, the bottom of the oven interior tends to get stained

WHAT TO DO IF REPAIRS ARE NEEDED

1. If any of the following appear, check for a problem.
"U-50" flashes in the display window.
When using Programme Selection Keys the key must be touched
within 1 minute of closing the door.
After inserting the power plug into the wall outlet, open and close
the door and then touch the key.
→ Open and close the door, and then touch the key before 1
minute passes.
*The purpose of this function is to prevent operation when there
is no food in the oven.
"U-10" appears in the display window.
The oven operates empty without food in it.
→ Touch CLEAR key, place food in oven and start again.
2. This is normal operation:
Cooling fan operates for a while after heating has completed or
heating has been stopped by opening door or touch CLEAR key
during operating.
→ Cooling fan operating continues for five minutes to keep the
electronic components cool.
3. This is abnormal operation:
Get in contact with your nearest Service center or retailer.
This oven is provided with self-diagnostic function.
– When the window display indicates the error code "E"
(example: E-21), it shows to need repairing by a technical service
engineer. Remove the power supply plug from wall outlet and
call a Service Center.
– When the magnetron indicator in control panel lights, it shows
that remaining magnetron life became short. Call a Service
Center to replace the magnetron before it becomes defective.

SPECIFICATIONS AND ACCESSORIES

Specifications
Microwave power output
Microwave frequency
Outer dimensions
Cavity dimensions
Weight
EM-C1800K
1800W~ 180W
2450 MHz
422(W) × 560(D) × 335(H) mm
330(W) × 330(D) × 175(H) mm
32.5 Kg (72lbs)
from spices and food. Since this may cause odour and abnormal
vibration, be sure to keep this area clean.
CAUTION: Do not wipe plastic and painted sections of the oven
with bleach, thinners or other cleaning agents, as this
may cause these parts to dissolve or change shape.
3. The stirrer shield (inside oven top) can be gently wiped in place or
removed for washing at the sink. The shield is a mica, supported
at side and rear. Carefully remove the shield, pull forward to
remove. Wash only in warm (not hot) detergent water, rinse and
wipe dry. Avoid hitting or bending the metal stirrer blades, as this
could change the heating pattern in the oven.
To replace the shield, position it on the rails on sides and rear of
the cooking chamber.
4. Clean the removable air filter regularly. (at least once a week)
Do not operate oven without air filter in position.
* On no account remove or interfere with any parts or screws.
"THIS COULD PROVE VERY DANGEROUS."
Make the following simple check-up before contacting a Sanyo
Service Centre:
* If the interior lamp does not light when one of the programme
selection key is touched.
1. Make sure that the mains lead is securely plugged in.
2. Check the fuse in the plug top and ensure the plug top is wired
correctly.
Note: The appliance must be protected by a fuse.
3. Make sure that the door is completely closed.
4. Make sure that a programme has been stored.
* Before changing the interior lamp, please confirm the power
supply plug is disconnected from the socket.
* If the interior lamp lights and the appropriate power select or
preset cooking indicator is illuminated but the food is not heated;
1. Make sure that the food is not completely covered with a metal
container.
* Abnormal noise during operation.
1. Make sure that sparking during microwave cooking is not
caused by using unsuitable utensils of metal or having metal
bands or trimmings, or aluminum foil or skewers.
2. Make sure that the tray is set in the oven properly.
3. Check whether foods or containers are touching inside walls of
the oven.
* If smoke is observed, keep the oven door closed and switch
off by disconnecting the oven from the power supply.
Accessories
Menu Sheet . . . . . . . . . . . . . . . . . . . . 1
Operating instructions . . . . . . . . . . . . . 1
Air filter . . . . . . . . . . . . . . . . . . . . . . . . 1
28