Installing/Removing Battery Pack; Automatic Shut-Off - Ryobi P3100 Manuel D'utilisation

INSTALLING/REMOVING BATTERY PACK

See Figure 3, page 10.
 Make sure the on/off switch is in the off position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.
INSTALLING/REMOVING POWER CORD
See Figure 4, page 10.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Remove the battery pack.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
SPONGE TRAY AND SPONGE
See Figure 5, page 9.
 Insert sponge tray into the base as shown.
 For use, wet the sponge, squeeze out excess water, and
place into tray.
NOTE: Remove the tray for easy cleaning.
ON/OFF/TEMPERATURE CONTROL SWITCH
See Figure 6, page 10.
The LED indicator will light up when a charged battery pack
is installed or an extension cord is connected and the switch
is turned to the on position. If the indicator light is on, the
tip is heating.
 Connect the product to an AC or DC power supply.
 Place soldering pen in holder.
 Press the on/off/temperature control switch to turn on
the soldering iron.
NOTE: The LED indicator will glow solid red until the tip
has reached the selected operating temperature. Once
the selected temperature is reached, the indicator will
glow solid green.
OPERATION
 Select desired temperature by rotating the on/off/tem-
perature control switch.
NOTE: The temperature range can be adjusted from
400° F to 900° F.
 Press the on/off/temperature control switch again to turn
the soldering iron off.
NOTE: The LED indicator will flash slowly until the tip has
cooled. Do not touch the tip while the LED indicator is
solid or flashing.

AUTOMATIC SHUT-OFF

After 10 minutes of operation, the unit will automatically enter
an energy saving mode and the LED will slowly fade green.
To exit this mode, rotate the control slightly in either direction.
After 20 minutes of being in the energy saving mode, the unit
will turn off. This preserves the tip and prevents powering
an unattended tool.
OPERATING THE SOLDERING IRON
See Figure 7, page 10.
 Always hold the soldering iron pen as shown. Apply solder
with the tip of the pen.
NOTE: The hybrid soldering station features a grounding
loop for use when soldering circuitry or other static-
sensitive materials. It is recommended an ESD safe
strap (not included) be used when soldering sensitive
electronics.
 Apply the tip of the soldering iron at the point where the
soldering wire touches the workpiece.
 After soldering, return the pen to the pen holder. Press
firmly to make sure it is secure.
 Press the on/off/temperature control switch to turn the
soldering iron off.
NOTE: The LED indicator will flash until the tip has cooled.
Do not touch the tip while the LED indicator is flashing.
 Clean the soldering tip as described in the Maintenance
section of this manual.
WARNING:
Always place the pen back into the holder so that the tip
does not come in contact with anything while it is heating
or when not in use. Following this rule will reduce the risk
of damage to items, burns, fire, or serious personal injury.
 Always allow 30 minutes for the soldering iron to cool
before storing the tool.
7 — English