Assembly; Operation; Applications; Installing/Removing Battery Pack - Ryobi P3105 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Do not hold the soldering iron pen with your fingers near
any metal part of the tool. The tip of the tool reaches
working temperature within seconds. Always assume
that the soldering tip is hot. Touching a hot soldering tip
can result in serious personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

WARNING:
Do not use or store the soldering iron near flammable or
combustible materials or liquids. These materials may
ignite when exposed to the high temperatures created
by the tip.

APPLICATIONS

You may use this product for the purposes listed below:
 Soldering circuits and electrical connections
 Soldering of jewelry, stained glass, and other crafts
WARNING:
Battery tools are always in operating condition. Place
the switch in the off position and remove the battery
pack when the product is not in use or when carrying
at your side.

INSTALLING/REMOVING BATTERY PACK

See Figure 1, page 7.
 Make sure the on/off switch is in the off position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.

ON/OFF SWITCH

See Figure 2, page 7.
The LED indicator will light up when a charged battery pack
is installed and the switch is turned to the on position. If the
indicator light is on, the tip is heating.
 Install the battery pack.
 Press the on/off switch to turn the power on.
5 — English