Kerbl Clipster DropiX Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
4. Operation, cleaning and care
Switching on and off:
Slide the On/Off switch forward to turn the device on. Slide the On/
Off switch back to turn the device off (fig. 1).
This clipper can be used via its cable as well as without its cable.
Connect the power pack to the device socket located on the bottom
of the device. Then connect the power pack to the power (fig. 2).
2
1
Cutting height adjustment:
The clippers have a 4-stage, cutting height adjustment via a slide switch (fig. 3). You can select between
1.0 mm, 1.3 mm, 1.6 mm and 1.9 mm.
Using the comb accessory:
Make sure that the clipper is switched off when installing and removing the comb. Four combs are
available (3, 6, 9, 12 mm) for different cutting lengths. Place the comb onto the clipping head, making
sure that it engages on the side (fig. 4).
Clean and oil the device on a regular basis to ensure the problem-free function and full functional
3
performance of the clippers.
Cleaning the clipping head:
The clipping head should be thoroughly cleaned once a day with regular use.
Switch the device off. Disconnect the device from the power supply. Remove the comb attachment and
press in the centre of the shearing blades to remove them (fig. 5). Remove the hair with the cleaning
brush.
Place the clipping head back onto the clippers as shown in fig. 6. Make sure that the maximum cutting
height (1.9 mm) is set and that the locking mechanism is positioned properly and press the cutter head
4
onto the device until it engages.
Oiling the clipping head:
The clipping head must be oiled to ensure the good cutting
results of the clipping head for as long as possible (during
operation every 15 min. and when stored, preferably on a daily
basis). Remove the comb attachment. Use the brush to clean
the cutting edge, removing the hair between the blades. Oil the
locations where the upper and lower part of the clipping head
touch. The device must be oiled immediately when the shearing
performance diminishes noticeably or the temperature of the
5
6
clipping head seems too high. The clipping head should be
oiled once per day when the clippers are not in use.
Replacing the clipping head:
The clipping head is a wear part. Despite good care, the cutting performance will diminish. At this point, the clipping head should be replaced.
The clipping head can be ordered individually as a spare part (ref. no. 18465). When replacing the clipping head, you can remove the residue
hair within the clippers using the brush. Press in the centre of the shearing blades to remove them (fig. 5). Place the new clipping head back onto
the clippers as shown in fig. 6. Make sure that the maximum cutting height (1.9 mm) is set and that the locking mechanism is positioned pro-
perly and press the cutter head onto the device until it engages.
Cleaning the device:
Wipe off your device occasionally using a moist cloth, then rub it dry.
12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

18461

Table des Matières