Intended Use; General Safety Instructions - Kerbl Clipster DropiX Mode D'emploi

Operating instructions
EN
1. Safety
Please read the instructions for use carefully before operating the clippers, especially the „Safety" section. This will help you avoid possible
hazards and protect against damage to the device due to misuse. Keep the instructions for use handy for future reference. If the device is passed
on to a new owner, please also hand over these instructions for use.
1.1 Explanation of terms and symbols
The following terms are used in these instructions for use:
If disregarded, can lead to serious injuries or death
DANGER
If disregarded, can lead to serious injuries (or death)
WARNING
Note Information that should be observed when handling the device.
Danger of an electric shock! The device may never be charged while in the bath, shower,
over a filled washbasin / other container.

1.2 Intended use

• the clippers are used to trim hair/fur
• the device is designed for indoor use only. It should not be operated outdoors (garden, terrace, etc.).
• if the device is used in a manner that does not comply with the intended use and/or if modifications are made to the device, then this voids the
manufacturer's warranty and liabilities
1.3 Important danger warnings
• the device's power pack should only be operated in dry areas. Do not use the device in the shower or bath when it is
connected to the power pack.
• completely dry the device after use before it is put away
DANGER
• if the device falls into water or becomes wet due to spray water, completely shake the water out of the connector plug and
On/Off switch before re-connecting the device for charging
• the integration of a residual-current-operated protective device, with a nominal tripping current of less than 30 mA, in the building installation
provides additional protection. We recommend that you have your electrician install residual current protection for your power circuits.
• the device must be disconnected from the power supply when the battery is charged or after at least 8 hours of pure charging time
• if the battery does not fully charge after 8 hours, do not operate the device and contact the manufacturer
The clipping head can become hot after extended use!
WARNING
The clipper may only be operated with a power pack that meets the specifications on the nameplate. The device may only be
operated with a power pack that delivers the SELV output voltage specified on the device's markings.
DANGER

1.4 General safety instructions

Never operate the device if:
• the device, charging tray or connecting cable is damaged
• the clipping head is damaged or chipped because this can injure the skin
DANGER
• the device is dropped, shows visible damage or its functionality is impaired
• the device is damaged so that electrical components are exposed
In each case, the device must be disconnected from the mains immediately!
10