Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Hip and knee prostheses (at high
vibration levels).
• Epilepsy.
• Use
of
osteosynthetic structures in general or
any other internally fitted electric
device.
• Tumours and metastatic processes.
• Being particularly tired, unwell or
overly stressed.
• Inflammation caused by injuries of
an electro-muscular nature.
• Do not use after surgery (for at least
2 months), post-traumatic situations or
transient generic illnesses such as
headache, backache, etc. ... until the
symptoms disappear.
• Vocal cord disorders.
• Use of contraceptive coils (IUD)
• Psychological
vibratory stimulation.
SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. The plug must only
be used with an appropriate wall
socket,
installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
plates,
pins
intolerance
correctly
electrician to install an electrical socket
that does.
This product must only be used on a
and
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not
use an adaptor with this appliance.
Always
recommendations when using electrical
appliances:
to
1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match the
pins for plug on the machine. Do not
use any type of adapter.
2 To reduce the risk of electrical shock,
always unplug the unit immediately
after use and before proceeding to
clean it.
and
3 Only plug the machine into suitably
earthed wall sockets, as shown in Fig.
A. An inadequate electrical connection
may result in electrical shocks. If the
plug is not suitable for the wall socket
then change it for one that matches,
bearing in mind that the earth wire
must always be connected. If in doubt,
call technical services.
4 Never leave the unit unattended
when it is plugged in. Unplug it after
use.
11
observe
the
following
Publicité
Table des Matières
