Water Inlet Filter Cleaning; Lances' Sprinkler Nozzles; Changing/Repositioning The Pump Oil; Cleaning And Storage - VITO WR1 115B PRO-POWER Mode D'emploi

EN
� Clean dust and sand from the
connectors;
� Clean the sprinkler nozzle regularly;
5.1 - WATER INLET FILTER
CLEANING (FIG. K)
Clean the filter regularly, once a month
or more frequently depending on the
times of use.
1. Untighten and remove the water inlet
filter (9);
2. Remove the filter element and wash
it with tap water until being completely
clean;
3. Insert the filter element on the filter;
4. Tighten the filter in the water inlet;
5.2 - LANCES' SPRINKLER
NOZZLES (FIG. L)
The clog of the sprinkler nozzles (1)
causes a significant reduction in the
water flow, leading the machine to an
intermittent operation.
When it happens, follow
instructions:
1. Turn the machine off in the "ON/
OFF" switch (8) and remove the power
cable (7) from the socket;
2. Close the supply water tap;
3. Press the gun trigger (21) to release
the pressure on the hose;
4. Remove the lance (2);
5. Rotate the sprinkler nozzle (1)
counter clockwise, until its limit, to
open the vanes;
6. Insert a needle inside the sprinkler
nozzle hole and move it forwards and
backwards until unclog. The impurities
must exit through the
extremity;
30
5.3 - CHANGING/
REPOSITIONING THE PUMP
OIL
The pump was dimensioned to run
with the same oil during the machine's
service life.
However, in case of leak, stop the
machine immediately and call technical
assistance.

5.4 - CLEANING AND STORAGE

Cleaning
Clean the machine after each use.
Careful handling protects the machine
and extends its lifespan.
Storage
The machine should be stored in a dry
place, mainly in the winter, to avoid
damages caused by the ice.
1. After finishing, remove the water from
the pump, press the gun trigger until
there's no water in the sprinkler nozzle;
2. Disassemble the pressure hose, gun
these and lances;
3. Drain the water from every accessory
and use a clean cloth to clean the hoses
and accessories exterior;
4. Clean the water inlet filter and the
sprinkler nozzle;
5. Put the cover in the water inlet;
6. Store the machine in a clean and dry
place;
opposite
6. ENVIRONMENT
PROTECTION
The packaging is made up of
recyclable materials that shall
be disposed through local recycling
points.
Never place electrical tools
in the household waste!
According to the European Directive
2012/19 / EC on electrical and
electronic equipments waste, and its
transposition into national law, every
used electrical machines must be
collected separately and delivered to
the collection sites provided for this
purpose.
You can obtain information about the
disposal of old devices through the
legal responsible for recycling in your
city.
7. COSTUMER SUPPORT
Tel.: 256 331 080
E-mail: sat@centrallobao.pt
Site: www.centrallobao.pt