Problems & Solutions - ZEN AROME ELEGANSIA V2 Manuel D'utilisation

Cleaning the ceramic disk:
Clean the ceramic disc and the surface of the mist maker with soft cloth or cotton sticker in
clean water with some white vinegar. Also, you can place 2 to 5 drops of white vinegar on
the ceramic disk and leave for from 2 to 5 minutes.
- Prohibited to touch or scratch the ceramic disc or the water lever sensor switch.
- Don't use washing powder to clean any part of the diffuser.
- Rinse the base reservoir in clean water.
- Do not use soap, solvent or a spray on cleaning agent to clean the ceramic disk.
Don't pour water, nor wet, nor block the little fans output.
To clean the water tank:
1) Clean the water tank using a soft cloth and with white vinegar if inside is dirty.
2) If the ceramic disc is covered in scum, put a few drops of vinegar on it and clean it with
the soft brush.
3) Rinse the water tank in clean water.
Storage:
Store the device in a clean, dry place, out of the reach of children, having cleaned and dried
it.
VI. PROBLEMS AND SOLUTIONS
If the diffuser does not operate properly under normal conditions of use, consult the
following table:
Problems
If there is no light.
No blowing, no
Main switch off.
mist,
The water level in the reservoir is too
no indicator
high (>100 ml).
lights
Water is leaking from the reservoir.
No water in the reservoir or the
reservoir does not contain more than
Blowing, but
20 ml.
no mist
The temperature of the unit is too low.
Mist with an Water has been stagnating for too long
unusual smell in the reservoir.
Too much water in the reservoir.
The mist intensity control has set to
minimum.
Sediment on the ceramic disk.
Low intensity
The water is too cold.
The water is not clean.
Possible causes Solutions
Check the device is plugged in or that there
is not a power failure.
Switch on the main switch.
Remove some water from the reservoir.
Check that the lids are closed properly.
Fill the reservoir with fresh water.
Place the unit in a room at ambient
temperature for half an hour before use.
Clean the reservoir and fill it with fresh
water.
Remove some water from the reservoir.
Adjust the control button.
Clean the ceramic disk.
Use water at ambient temperature.
Clean the reservoir and fill it with fresh
water.
EN
11