Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
worn outlet /receptacle/ may result in
overheating of the power cord or fire.
- WARNING: Do not cover the appliance
while it is functioning in order to
avoid overheating which may cause
risk of fire.
Symbol meaning
This simbol indicates:
(If provided) Class II equipment
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polythene tape used as carry handle,
remove it before connecting appliance
to the outlet.
- Always use the appliance in an upright
position.
- To disconnect heater, turn controls to
off, then remove plug from outlet.
- Connect to properly polarized outlets
only.
- This heater is not intended for use
with an extension cord or outlet
strip. Plug the cord directly into an
appropriate wall receptable.
- Check that neither the appliance nor
the power cable have been damaged
in any way during transportation.
- Make sure that no pieces of polystyrene
or other packaging material have
been left on the appliance. It may be
necessary to pass over the appliance
with a vacuum cleaner.
- When switching on the appliance for
the first time, allow it to run at full
power for at least two hours to get
rid of the unpleasant smell. Make sure
that the room in which the appliance
is located is well ventilated during
this operation. It is normal for the
appliance to emit small cracking
sounds when you turn it on.
- Do not use the appliance in rooms
with a floor area of less than 4mq (43
square feet).
- Before putting the appliance away,
make sure it is completely off and
unplugged from the mains socket.
Wrap the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not place the heater near a bed
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
- This appliance is not intended for use
at altitudes exceeding 2000 m.
- A tip over safety device turns the
appliance off if it falls over or is
positioned inappropriately in such
a way as to jeopardise safety. The
appliance emits a beep and a dot
flashes on the display. The appliance
resumes operation a few seconds after
being placed in an upright position
again. See troubleshooting session.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
13
Publicité
Table des Matières
