Sauber V90 Mode D'emploi page 13

V90
COMPONENTS LIST
1. Suction nozzle
2. Dust container
3. Filter assembly
4. Container opening button
5. Indicator light
6. ON/OFF switch
7. Handle
8. Charging base / wall-mounted bracket
9. charger
10. Brush attachment
11. Crevice tool
12. Brush
13. Rubber tool
OPERATING MODE:
1. Fixation of the wall-mounted bracket
The charging base can be mounted onto the wall. Measure the distance between the holes situated at the
bracket and drill two holes in the wall with the proper distance. Put the plastic expansion bolts into the
holes and screw the screws into the expansion bolts. Align the holes with the screws and mount the bracket
onto the wall.
2. Charging the device

Always make sure the vacuum cleaner is turned off before connecting to the charger.

Place the vacuum cleaner into the charging base and plug the charger into a suitable socket outlet. Make
sure the suction nozzle is facing upwards and the charging pin is inserted into the little socket on the vacuum
cleaner. During the charging process the indicator light will blink in red. When the vacuum cleaner is fully
charged, the red light will stop blinking and illuminate still.

The complete cycle of charging lasts 3-4 hours.

The suction power will decrease when the battery gets low.

Don't let the deoice uncharged nor a long time, because the inner accumulators may be damaged.

In order to ensure that it is always ready for use, the device could be left on charge with the charger when
not being used.

The charger may become warm during charging --- this is normal.
- 12 -
EN