DS Produkte 01175 Mode D'emploi page 23

■ Do not iron across zippers, rivets, buckles etc. to avoid scratches on the coating of
the soleplate.
■ Only open the water tank cap to fi ll the water tank. Otherwise keep the cap closed
during operation.
■ Always place the device on a level, stable base.
■ During and shortly after use, place the device on the storage tray or on the support
foot and on a level, stable, heat and moisture-resistant base.
It is possible that a mild odour is produced the fi rst time you use the device. This
is harmless and will cease as you use the device.
Filling the water tank
ATTENTION!
■ Scalding hazard due to hot steam! Let the device cool off before opening the water
tank.
■ Always pull the mains plug before the water tank is refi lled / emptied. Never pull on
the mains cord, but always on the mains plug.
■ Never fi ll the water tank with additives. The device could be destroyed and safe op-
eration of the device can no longer be assured.
■ Never exceed the maximum level.
The water tank (7) must be fi lled for steam ironing. This is omitted when dry ironing.
1. Make sure that the device is not connected to the mains supply. Set the On/Off switch
for the heat function of the water tank (A) to position 0 (steam production off) and the
temperature control (2) to position 0 (turn 0 to the mark (on the temperature control
light 3)).
D
Heating up the iron
1. Check the label on the article of clothing for the required ironing temperature (see
chapter "Ironing recommendations") and set it with the temperature control (2).
2. Set the On/Off switch for the heat function of the water tank (A) to position
emission off).
3. If you haven't already done so, place the device on the ironing board or a stable,
level, heat and moisture-resistant base.
4. Place the iron on the storage tray (8).
5. Insert the mains plug in a properly installed socket that is easily accessible.
6. Set the On/Off switch for the heat function of the soleplate (C) to position
on).
23
2. Turn the water tank cap (D) open.
3. Fill the water tank (7) with distilled water. It holds approx.
500 ml. Use the measuring cup to fi ll it.
4. Firmly turn the water tank cap (D) until tight.
EN
0
(steam
I
(soleplate