Alecto PAS-215A Mode D'emploi page 37

PAIRING WITH A BLUETOOTH
To use the Bluetooth
with the Bluetooth
or other). The pairing process is as follows:
1. Turn on the search function on the Bluetooth
manual of that device).
2. Turn on the MP3 player of the PAS-215A, and then briefly press the "MODE"
button several times until "Bluetooth" appears in the display.
3. Now select "ALECTO" in the list that appears in the display of the Bluetooth
device containing the music to be played.
4. If asked, enter the password or PIN code "0000".
5. Depending on the device containing the music, you should set this device to
not play music through the headphones output or its own speaker, but to send
the signal to the MP3 player (refer to the user's manual of that device).
Attention: the MP3 player only plays music and does not support phone
calls.
The supplied wired microphone can be connected to the XLR connection of the
microphone input; this microphone has a balanced output.
Don't forget to set the switch on the microphone to 'on' before you start speaking.
While speaking, slowly turn the volume control up. When the microphone volume
is too loud, the sound can start whistling (feedback). When this feedback lasts for
too long, the speaker can get damaged. Keep the microphone approx. 2cm from
your mouth. Speak loudly, clearly and not too fast into the microphone.
®
function of the PAS-215A, the MP3 player must be paired
®
device containing the music to be played (mobile phone, tablet
®
MICROPHONE
AUDIO SOURCE:
music source (refer to the user's
®
37
®