Product Presentation - CDVI Wiegand KCPROXWLC Manuel D'installation

MANUEL D'INSTALLATION
KCPROXWLC
Dual Technology Digicode

1] PRODUCT PRESENTATION

Dual technology:
- Proximity reader,
- Digicode keypad.
®
Output formats:
- Wiegand,
- Standard format,
- ISO Track 2 format.
Stainless steel.
Narrow: Ideal for installation
on aluminium profile.
Backlit.
Recommended for activating
and deactivating your alarm system.
Surface-mount.
Mounting with Diax
Audible and visual feedback.
Dimensions (L x W x D): 190 x 43 x 27mm.
Power supplies: 12V dc.
Consumptions: 120mA.
2] NOTES & RECOMMENDATIONS
Operating modes
CENTAUR :
3 operating user modes with CENTAUR:
- Digicode keypad only,
®
- Proximity reader only,
- or dual security (Proximity reader + Digicode
The operating mode is programmed on Centaur software.
TERENA/UGM-UGL :
There are only 2 operating modes possible
on TERENA or UGL/UGM:
- Digicode keypad,
®
- Proximity card reader.
Program the proximity card or the pin code
on TERENA or UGL/UGM software.
Cable
- Programming your installation before installing
products on site.
- The distance between a CT-V900-A controller
or a LINKNET controller and a KCPROXWLC
should not exceed more than 50 meters.
- Make sure not to exceed 50 meters between
the INTBUSW reader interface and the KCPROXWLC
Pin/Prox Digicode .
®
cdvi.com
2
cdvigroup.com
/Proximity reader - Wiegand
®
screws.
®
keypad).
®
- Make sure that the cable is not near by a high
voltage cables (ex: 230 V AC).
- Recommended cable 2 twisted pairs (4 wires)
SYT1 0.8MM.
Back EMF protection
To secure the system from back electromagnetic
fields do not forget to mount the varistor in parallel
on the lock terminals.
Security Advice
- For security reasons, change the factory default
master code.
- When selecting a master code and user code
avoid simple codes (example : 3 4 5 6 7).
Mounting recommendations
Mount the keypad on a flat surface to avoid
any vandalism and to insure the best mounting.
Power Supplies
Recommended power supplies: ARD12 or BS60.
These products must be powered in 12Vdc and the
power supply should be certified EN60950-1:2006/
A11:2009 standards and should be designed to be
a low power supply source.
EN
CE Certification
IP64
Environmental tests:
vibrations
-25°C à +60°C
WEEE & RoHS