Party Light & Sound PARTY-FOG1200LED Mode D'emploi page 3

• Put the unit on a level surface and don't tilt or turn it upside down.
Power off or pull out plug after use.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
•
qualified persons in order to avoid hazard.
The unit is not waterproof, if there is some humidity, water or fog liquid in it, please switch off the power and
•
contact the distributor as soon as possible.
• There are no spare parts inside machine. If the unit needs to be repaired, please contact your dealer of an
experienced technician.
• Keep out of the reach of children. Don't leave the unit unattended when children are present.
Don't spray the fog directly to people and into an open flame.
•
The nozzle becomes very hot during operation. So please leave at least 1m distance between the unit and
•
other materials.
Put the machine at a well-ventilated place and don't cover the ventilation holes. Leave at least 1m of space
•
around the fog machine. Keep a distance of at least 3m between the fog machine and inflammable
materials.
Don't add tinder liquid such as oil, gas, perfume and etc. in fog machine.
•
Please use high quality fog liquid recommended by your dealer. Bad quality fog liquid may damage the
•
unit.
Check regularly if there is enough fog liquid left in the tank.
•
• Remove all fog liquid from the unit before transport.
Don't swallow fog liquid. In case of accidental ingestion, contact immediately a doctor. Rinse thoroughly
•
your skin and eyes if they have been in contact with the fog liquid.
Repair:
Please clean the fog machine regularly to avoid problems. Close the cap of the fluid tank thoroughly after filling
in fog liquid. After about 40 hours continually use, please use 80% distilled water and 20% vinegar to remove
the dirt in the nozzle. Let the unit cool down. Disassemble the nozzle and use vinegar and a pipe cleaner to
clean it. Make sure that the unit is unobstructed. Empty the tank and fill in cleaning fluid. Plug the unit into a wall
outlet and heat it up as usually. Run it in a well-ventilated place until the tank is empty.
Replace the nozzle. Unplug the unit and fill it with normal fog fluid.
Clean timely to extend the lifespan of machine. Use dry cloths to clean machine and keep dry while store.
Technical parameter:
Voltage: ............................................................................................ AC 110-240V 50/60Hz
Power consumption: ................................................................................................ 1250W
Fuse .................................................................................................................................. 8A
LED ................................................................................................. 6 x 3W RGB 3-in-1 LED
Heat-up Time: ............................................................................................................. 3 min
Tank Capacity: .............................................................................................................. 1.5L
Projection Distance: ........................................................................................................ 3m
Smoke Output: ...................................................................................................... 99m³/min
Weight: .......................................................................................................................... 3KG
Dimensions: ......................................................................................... 350 x 250 x 270mm
Electric products must not be put into household waste. Please bring them to a recycling
centre. Ask your local authorities or your dealer about the way to proceed.
©Lotronic- 2017 PARTY-FOG1200LED 3