Télécharger Imprimer la page

Party Light & Sound PARTY-FOG1200LED Mode D'emploi page 2

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
G
B
-
1
2
G
B
-
1
2
Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or
damage due to misuse. Thank you for purchasing this high quality, well-performing fog machine that
will give you entire satisfaction.
The appliance is only to be used with the recommended vaporizing medium. The use of other substances
may give rise to a toxic or fire risk.
This appliance shall not be used by children below the age of 14 nor persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge even if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children.
Please note that the unit is not for intensive professional use. FOR SAFETY REASONS, DO NOT
LEAVE THE UNIT SWITCHED ON OVER AN EXTENDED PERIOD OF TIME.
Installation:
1. Take away all packing material especially in the nozzle.
2. Set the unit on a level surface and loosen the cap of the fluid tank.
3. Add high quality water based fog liquid in the machine and screw the cap of the fluid tank. Bad quality fog
liquid will damage fog machine.
4. Plug the unit into an earthed mains outlet.
Operation:
1. Please turn on the unit via the switch on the rear panel. The machine will
start heating up. When it has reached operating temperature, the red
LED on the wired remote control lights up. When the LED goes off, the
unit has cooled down and requires re-heating, the pump will not operate
and the LEDs don't light up whilst the heater is on. The switch will
illuminate when the machine is again ready to use.
2. Press the A button on the remote control to switch the LEDs off.
3. Press the B button on the remote control activate the LEDs in music
controlled mode.
4. Press the C button on the remote control select a color.
5. Press the D button on the remote control to produce fog for 30 seconds.
6. Often check whether there is enough fog liquid in the tank. The machine might be severely damaged if it
runs without fog liquid.
7. If the fog output is low, the unit makes an unusual noise or there is no fog output at all, please power off and
check fog liquid, fuse and power plug. If the problem hasn't been solved after checking these parts, send it
back to your dealer for repair.
Attention:
Please adhere to all operation, safety and repair instructions to avoid getting an electric shock and keep
the unit in excellent working condition.
For indoor use only
Make sure your mains outlet delivers the voltage required for this fog machine.
©Lotronic- 2017
0
0
W
F
o
g
0
0
W
F
o
g
PARTY-FOG1200LED
M
a
c
h
i
n
e
M
a
c
h
i
n
e
w
i
t
h
6
L
E
w
i
t
h
6
L
E
D
s
D
s
2

Publicité

loading