CASCO FX70 Mode D'emploi page 11

Table des Matières

Les langues disponibles

MANUAL FOR CASCO SKI

GOOGLES AND SNOWmasks

Use of the Ski goggle/SNOWmask

CASCO ski goggles and SNOWmasks are pieces of personal protective

equipment (PPE category 1 to protect users against low risks) and should

be used for alpine skiing. CASCO ski goggles/SNOWmasks have been

designed and manufactured to the highest standards. They offer protection

from the cold, snow, wind, dust and damaging ultra-violet rays while

offering suitable protection against minor external blows. The ski goggles/

SNOWmask cannot protect against strong impacts, excessively accelerated

flying parts or collision.

CAUTION! Do NOT use these goggles while driving in traffic, do NOT

look directly into the sun!

This sports eyewear has been manufactured from materials for temperatures

to -20° C. These goggles/SNOWmasks will not produce skin irritation or affect

the health in those who are in a normal state of health.

An artificial foam mixture that is particularly gentle to the skin cushions

CASCO sports eyewear between the frame and the face. The foam is soft

and forms the contours of the face, is highly absorbent. The elastic headband

offers a firm grip.

After a blow to the goggles/SNOWmasks or after a fall or after a longer length

of storage the shield, the frame and the band must be checked for damage.

CAUTION! Damaged, scratched or splotchy shields should not be used

but should be replaced by CASCO original parts. The same goes for

frames that may have become damaged.

Adjusting and replacing

SNOWmask

Before putting on the helmet, you must first push up the CASCO SNOW/mask

and secure it in the snap-in mechanism. To replace the CASCO SNOWmask,

first disengage carefully the studs inside the helmet. Now you can remove the

CASCO SNOWmask by pulling the stud through the openings in the side of

the helmet.