Operating Determinations; Installation - Omnitronic BD-1520 Mode D'emploi

3. OPERATING DETERMINATIONS

This device is a professional turntable for playing standard LPs or Singles. This product is allowed to be
operated with an alternating current of 115/230 V, 50/60 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
The ambient temperature must always be between -5° C and +45° C.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

4. INSTALLATION

Install the turntable on a plane, stable ground.
Place the platter on the holder.
Turn the platter until the rectangular whole is at approx. 20°. Connect the belt with the driving pinion.
Place the slipmat on the platter.
Remove the hinges from the bottom side of the styrofoam. Install the dust-cover on the two hinges.
Remove the pickup-system from the cartridge holder and screw it on the tonearm
12/23 10603045_V_1_3.DOC