Cooking Waffles - Hatco FWM Série Manuel D'installation Et D'utilisation

OPERATION
4. Press the button to turn on the waffle maker.
• The button will illuminate green, the LED display
will show the current temperature of the unit, and
preheating will begin.
5. With the cooking plates closed, allow the waffle maker to
preheat for approximately 8–10 minutes.
• When preheating is complete, three short beeps will
sound and the LED display will show the current timer
setting.

Cooking Waffles

The timer on Hatco Flip Waffle Makers is designed to operate
automatically. If desired, the timer also can be operated
manually. The following procedure is written for automatic
operation.
Automatic Operation—A magnetic sensor near the cradle
on the rear housing senses the presence of the cooking plate
assembly. When the waffle maker is opened completely and
the cooking plate assembly nears the cradle, the sensor
signals the unit to stop/reset the timer. As soon as the cooking
plate assembly locator pin moves out of the cradle, the sensor
will signal the unit to start the timer.
Manual Operation—Press the
stop the timer at any time.
NOTE: For manual operation, do not open the waffle maker
completely. If the cooking plate assembly gets too
close to the cradle, the magnetic sensor will detect its
presence, and the timer will be controlled as described
in "Automatic Operation" above.
1. Make sure the "Startup" procedure is complete.
NOTE: Use an oil-based food release spray on the cooking
plates to ease waffle removal, if necessary.
Handle
Top
Cooking
Plate
Bottom
Cooking
Plate
Drip Tray
Waffle Maker in Fully Open Position
Enter button to start or
8
2. Open the waffle maker completely, and spread waffle
batter onto the bottom cooking plate. The amount of batter
will be determined by the type of batter and the size of the
cooking plates.
3. Close the waffle maker.
• The LED display will flash "FLIP" for five seconds, and
the timer will start automatically.
4. Grasp both handles, and rotate the waffle maker 180° in
the direction shown by the arrow on the front of the top
cooking plate.
• Rotating the waffle maker helps to distribute the waffle
batter evenly in the cooking plates.
Cradle
Arrow
Rotating the Waffle Maker
• When the cooking cycle is complete, three short beeps
will sound and the LED display will flash zeros.
5. Carefully open the waffle maker completely, and
immediately remove the waffle using the included waffle
fork or other appropriate utensil. NOTICE: Do not use
metal utensils on Teflon
will occur. Use high heat-rated plastic and silicone
utensils only.
• Opening the waffle maker completely will reset the timer
automatically.
NOTE: The timer can be reset and restarted at any time by
pressing the button.
6. Continue to cook waffles by repeating steps 2–5 of this
procedure.
• If the waffles begin sticking to the cooking plates, spray
the top and bottom cooking plates lightly with an oil-
based food release spray. Continue to spray the plates
in between waffles as needed.
English
Locator
Pin
coated surfaces. Scratching
®
Form No. FWMM-0121