EUROM LO50 Manuel D'instruction page 24

the dehumidifier without a filter! If also the element (2) is dirty, you can clean it
carefully with a brush, see fig.
The housing and the water reservoir can be cleaned with a damp cloth and a mild
cleaning agent. Never use corrosive or abrasive products as these could damage
the finish.
Always remove the plug from the socket before carrying out any cleaning work!
Error messages and problem solutions
Error messages
The following error messages could appear on the display:
E1: Problem in the humidity sensor
E2: Problem with the sensor for defrosting pipes
Problems and solutions
The device does not work
 Device is switched off – switch it on
 Power failure – wait until power is restored
 Plug not (correctly) inserted into socket – reinsert plug
 Water reservoir full – drain it
The device is not dehumidifying very effectively
 Filter blocked by dirt – clean filter
 Obstacle in air inlet or outlet – remove blockage
 Door or window open – close the door or window and shade the sun
 Coolant leakage – contact a service department
Water leak
 Device tips over – place on a stable and horizontal surface
 Drain is blocked – remove blockage
Peculiar sounds
 Device is not stable – place it on a stable and horizontal surface
 Filter is blocked – clean filter
1. When you switch the device on or off, the circulation of the coolant can make a
certain amount of noise; this is perfectly normal.
2. The air that is emitted from the air outlet may well be warm; this is perfectly
normal.
3. If you cannot resolve the issue with the above instructions, please contact your
supplier or a recognised repair company. Never open the device yourself!
24