EUROM LO50 Manuel D'instruction page 23

restarted within three minutes of switching the device off. It is, therefore,
possible that the motor will not immediately respond to being turned off or on!
 When the temperature is low, keep an eye on whether the device needs to
defrost. When defrosting, the relevant light will come on and the fan will run but
the compressor will automatically switch off.
 The devices have an automatic memory that automatically stores the settings
and also saves if the power supply fails or is interrupted. Once the power supply
has been restored, the device will start to work according to the previously
entered settings.
 The display will show a humidity level of 30% to 90%.
 Remove the plug from the socket if you do not plan to use the device for an
extended period.
 If the water collecting tank is full, the light will come on and the compressor and
fan will automatically shut down. You will also hear a beep. If you do not drain
the water collection tank, the beep will be repeated every 5 minutes. Only once
the water collection tank has been emptied can the device be used again.
 You can install a continuous drain by removing the water collection tank, taking
the rubber bung out on the side of the water collection tank and connecting a
hose to this outlet. Then replace the water collection tank and run the hose from
the device (downwards) to a suitable drainage point.
 In order to avoid damaging the compressor, never place the dehumidifier on a
slope of over 45°.
 The device works between 5°C and 32°C.
 When being used, the compressor will emit heat which can increase the ambient
temperature by between 1 and 3°C. This is perfectly normal.
 If the indoor temperature is lower than 10°C and air humidity is pretty low, you
will not need to use the device.
 Ensure that there is at least 10 cm of free space between the air inlet and the
outlet opening and any solid objects, e.g. a wall.
 Try to ensure that the room is as well sealed as possible in order to improve the
dehumidification result.
Cleaning
Too much dust on the filter will impact upon the device's ability to dehumidify.
Clean the filter regularly (at least once a
month); if the device is placed in a dusty
environment, you should clean it weekly or
even daily. To do so, open the front panel and
take the filter (1) out. Remove the loose dust
by carefully knocking the filter. Then vacuum
the filter gently or wash it in lukewarm water
with a little, mild soap. Leave to dry thoroughly
before repositioning in the device (follow the
above instructions in reverse order). Never use
23