EUROM LO50 Manuel D'instruction page 22

The water collection tank is equipped with a water discharge pipe, to which a 1/2
"hose must be connected via the side (by means of a hose clamp). Place the end of
the hose in a well, drain or other waste water outlet. Ensure that the hose runs
downwards without knicks.
Control panel
1. ON/OFF button
2. Humidity up button
3. Humidity down button
4. Humidity display
5. In operation symbol
6. Water collection tank full symbol
7. Defrosting symbol
8. Fan
9. Hour meter
Starting and operating
Make sure that the socket to which you want to connect the dehumidifier has the
same voltage as stated on the rating plate: 220-240V ~ 50Hz.
Plug it into the socket; the device beeps.
Press the on / off button. The display shows the "operating symbol" and the current
humidity. When the "in operation symbol" flashes, the humidity is lower than the
set humidity.
Press the humidity up or humidity down button to set the percentage of the
humidity. Each time you press the humidity up and humidity down buttons, you set
the desired humidity to 1% higher or lower. If the set humidity is more than 3%
lower than the current humidity, the device starts operating until the current value
is 3% lower than the set humidity. Then the device turns off.
If you set the humidity to less than 30%, the device will continuously dehumidify.
The display will then show "CO".
The appliance is equipped with an hour meter, which counts how many hours your
appliance has worked in total (in units of 10 minutes).
Press the ON/OFF button again in order to switch the device off. The device will
come to a halt and the display goes out.
Note:
 If the set humidity is higher than the actual humidity, the device will not come
on.
 If you are dehumidifying, the fan motor and the compressor will run for at least
three minutes before the compressor starts. The compressor may not be
22