First Use; Attachment Fi Tting/Removal; Fitting Attachments; Removing Attachments - SilverCrest SWC 300 A1 Mode D'emploi

First use

GB
Attachment fi tting/removal

Fitting Attachments

Removing attachments

Switching on/off / Selecting a heat level
32
NOTICE
► If possible, preserve the appliance's original packaging during the warranty
period, so that in the event of a warranty claim you can package the appli-
ance ideally for its return.
■ Before taking the appliance into use ensure that ...
– the appliance and the attachments are in good working order,
– all packaging materials have been removed.
■ Clean all of the attachments as described under "Cleaning and care".
WARNING! RISK OF INJURY!
► After operation, the appliance components may be hot!
Fit the desired attachment into the attachment insertion slot 1, so that it
■
clicks into position.
■ First switch the appliance off and allow it to cool down..
Pull the attachment from the attachment insertion slot 1.
■
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
– "0" The appliance is switched off
– "C" for a cold air stream (Cool Shot)
– "1" for a warm air stream
– "2" for a hot air stream
You switch the appliance off by sliding the level switch 3 to the position "0"
■
(= appliance off ).
To fi x the styling, you can move the level switch 3 to "C". The styling will be
■
fi xed by the cool air stream.
SWC 300 A1