Technical Information; Installation Considerations - Hansgrohe Axor Starck Organic 12018 1 Série Instructions De Montage / Mode D'emploi / Garantie

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - 12018001
handshower
spout @ 44 PSI
Flow rate - 12016001
handshower
spout @ 44 PSI
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• This trim is for use with rough 10452181 (not
included). The rough must be installed and the
finished floor surface completed and made
watertight.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112°F.
• 12018001 only: The handshower is for use with
an automatically compensating valve rated at
1.3 GPM (4.9 L/min) or less.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
max. 1.75 GPM (6.6 L/min)
5.3 GPM (20 L/min)
max. 2.0 GPM (7.6 L/min)
5.3 GPM (20 L/min)
• 12016001 only: The handshower is for use with
an automatically compensating valve rated at
1.5 GPM (5.7 L/min) or less.
• The thermostatic mixing valve is for use with a
handshower rated at 1.7 GPM (6.4 L/min) or
higher.
• Protection against backflow is provided by check
valves.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.