Important Safety Instructions; Ground Fault Circuit Interrupter Protection; Extension Cords - Ryobi RY14122 Manuel D'utilisation

WARNING:
Read and understand all instructions. Failure to follow
all instructions listed below may result in electric shock,
fire, and/or serious personal injury.
WARNING:
When using this product basic precautions should always
be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
THIS PRODUCT
 To reduce the risk of injury, close supervision is neces-
sary when a product is used near children.
 Be thoroughly familiar with controls. Know how to stop
the product and release pressure quickly.
GROUND FAULT CIRCUIT INTERRUPTER
PROTECTION
This pressure washer is provided with a ground fault circuit
interrupter (GFCI) built into the plug of the power supply
cord. This device provides additional protection from the risk
of electric shock. Should replacement of the plug or cord
become necessary, use only identical replacement parts that
include GFCI protection.

EXTENSION CORDS

See Figure 1.
Use only extension cords that are intended for outdoor use.
These extension cords are identified by a marking "Accept-
able for use with outdoor appliances; store indoors while not
in use." Use only extension cords having an electrical rating
not less than the rating of the product. Do not use damaged
extension cords. Examine extension cord before using and
replace if damaged. Do not abuse extension cord and do

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
 Stay alert and exercise control. Watch what you are
doing and use common sense. Do not operate product
when you are tired. Do not rush.
 Do not operate the product while under the influence
of drugs, alcohol, or any medication.
 Keep the area of operation clear of all persons,
particularly small children, and pets.
 Don't overreach or stand on unstable support. Keep
proper footing and balance at all times.
 Follow the maintenance instructions specified in this
manual.
 This product is provided with a ground fault circuit
interrupter built into the power cord plug. If replace-
ment of the plug or cord is needed, use only identical
replacement parts.
 WARNING: Risk of injection or injury – Do not direct
discharge stream at persons.
not yank on any cord to disconnect. Keep cord away from
heat and sharp edges. Always disconnect the extension cord
from the receptacle before disconnecting the product from
the extension cord. Always plug the extension cord into a
GFCI protected outlet.
To avoid the possibility of the tool plug getting wet when
using an extension cord, arrange a "drip loop" in the cord
connecting the pressure washer to the extension cord. The
"drip loop" is that part of the cord below the level of the
connector which prevents water travelling along the cord
and coming in contact with the connection. If the plug does
get wet, DO NOT unplug the cord. Disconnect the fuse or
circuit breaker that supplies power to the tool, then unplug
and examine for presence of water in the connection.
WARNING: To reduce the risk of electrocution, keep all
connections dry and off the ground. Do not touch plug with
wet hands.
3 — English