Set-Up/Wall Bracket - Dentalux DAZD 3.7 Li A1 Mode D'emploi

CAUTION – PROPERTY DAMAGE!
The electric toothbrush may only be recharged with the supplied
►
charger. The appliance could otherwise be irreparably damaged!
Only operate the appliance with the original accessories supplied.
►
GB

Set-up/wall bracket

NOTE
The charger 8 may only be operated free-
►
standing if used in dry rooms.
► In damp rooms, especially in the vicinity of
water (bath), the charger 8 must be fi rmly
fi xed to the wall to protect it from falling into
water.
1) Press the small stand on the wall bracket 9
from below until this releases from the wall
bracket 9 with an audible „click":
24
2) Then pull the wall bracket 9 downwards
from the charger 8:
3) Using the screw holes of the wall bracket 9,
mark the spacing for the boreholes on the
wall. Check to ensure that there is a mains
power socket in close vicinity.
4) Before drilling the holes, check to ensure that
there are no electrical cables or water pipes
behind the markings.
5) Use a 5 mm drill bit to drill the required holes
and insert the wall plugs.
6) Affi x the wall bracket 9 using the screws
provided.
7) After you have attached the wall bracket 9,
guide the power cable through the right or
left cut-out in the wall bracket 8 (see magni-
fi cation on the fold-out page). Using the guide
rails, slide the charger 8 onto the wall
bracket 9.
8) Ensure that the power cable is not trapped
and that it lies properly in the cut-outs.
DAZD 3.7 Li A1