Reading The Set Date; Setting The Time And Date - Procheck WW1YB-3 Mode D'emploi

Attention!
• After the battery warning appears, the device is blocked until the batteries have been
replaced.
• Please use «AAA» Long-Life or Alkaline 1.5V Batteries. The use of 1.2V Accumulators is not
recommended.
• If the blood-pressure monitor is left unused for long periods, please remove the batteries
from the device.
Functional check: Press and hold the 0/I button to test all the display elements. When func-
tioning correctly all segments appear.

4.2. Reading the set date

Please press the «Time» key.

4.3. Setting the time and date

This blood-pressure monitor incorporates an integrated clock with date display. This has the
advantage, that at each measurement procedure, not only the blood-pressure values are stored,
but also the exact moment of the measurement.
After new batteries have been inserted, the clock begins to run from the following setting:
1997-01-01 00:00 O'clock.
You must then re-enter the date and current time. For this, please proceed as follows (Example:
Entering 1998-06-15 Time 09:30 o'clock):
1) Press the TIME button for at least 3 seconds.
The display now indicates the set year, during
which the last two characters blink.
2) The correct year can be entered by pressing
the MEMORY button. (Example: 1 x press)
M
6