Discontinuing A Measurement; Memory - Storage And Recall Of The Measurements - Procheck WW1YB-3 Mode D'emploi

b) After reaching the inflation pressure, the pump stops and
the pressure slowly falls away. The cuff-pressure (large
characters) is displayed during the measurement. When
the device has detected the pulse, the heart symbol in the
display begins to blink and a beep tone is audible for
every pulse beat.
c) When the measurement has been concluded, a long beep
tone sounds. The measured systolic and diastolic blood-
pressure values as well as the pulse frequency are now dis-
played. Example (Fig.): Systole 118, Diastole 73, Pulse 75
The measurement results are displayed, until you switch the device off. If no button is pressed
for 5 minutes, the device switches automatically off, to save the batteries.

5.5. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement
for any reason (e.g. the patient feelsunwell), the 0/I button
can be pressed at any time. The device then immediately low-
ers the cuff-pressure automatically.
5.6. Memory – storage and recall of the measurements
The blood-pressure monitor automatically stores each of the
last 30 measurement values. By pressing the MEMORY button,
the last measurement (MR1) as well as the further last
29 measurements (MR2, MR3, ..., MR30) can be displayed one
after the other.
DATE
MR
(MR1: Values of the last measurement)
DATE
MR
(MR2-MR30: Values of the measurement before MR1)
0/I
0/I
10