Cameo EVOS W3 Manuel D'utilisation page 6

7 STATUS LEDS NET
Yellow status LED lights up = network connection.
Green status LED flashes = control signal is present.
W-DMX™ ANTENNA
8
The antenna for W-DMX™ control remains in its holder during operation (= operating position).
9 LC DISPLAY
The backlit LC display shows the currently active operating mode (main display), the menu items in the Options menu, and the numerical
values or operating status for certain menu items. If there is no input within approx. 1 minute, the display screen automatically switches
to the main display. Note on the main display in operating modes with external control: As soon as the control signal is interrupted, the
symbols on the display will begin to flash. When the control signal is present again, the flashing will stop.
The battery-powered display can be activated even if the device is not connected to the power. To do so, press and hold the encoder for
approx. 5 seconds. You can now view device information and change and save system settings, even if the device is not connected to the
power. The spotlight's external controller will not activate in this case. This means that the display will show that there is no control signal
present, even if there is one present for the device.
10
PUSH-BUTTON ROTARY ENCODER
Push-button rotary push encoder for navigating the editing menu and for adjusting system settings and changing values in the correspond-
ing menu items. Starting from the main display, press the push-button rotary encoder to move to the main menu. Rotate the encoder to
select the individual menu items in the main menu (Control, Settings, Info, etc.) and in the submenu. Confirm your selection by pressing the
encoder. Rotate the encoder to change the value or status in a menu item and press the encoder to confirm the change.
6
9 10