Linea 2000 Domo DO930SBS Mode D'emploi page 46

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth.
· Avoid placing the cabinet in a narrow recess or near any leave source, direct sunlight, or
moisture.
· Let air circulate freely around the cabinet. Keep the rear of the refrigerator 7,5 cm away
from the wall.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated
on the rating label of your appliance corresponds to the voltage in your home. A different
voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 24 hours before turning it on. This way the
refrigerant can settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the
appropriate temperature.
· The climate class indicates the minimum and maximum ambient temperature for the
proper operation of an appliance. You can find the climate class on the type plate on the
back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
46
DO930SBS

Publicité

Table des Matières
loading

Table des Matières