Publicité
Les langues disponibles
Les langues disponibles
Fig. 4
IV. Base general view
As shown in Fig. 5.
6, 7, 8 and 9 – Temperature
button;
V. Use method:
1.
For burning the water, press the lid opening button shown in Fig. 6; the lid will open if
this button bounces and then you can remove it. If cooking the tea, you can directly
remove the lid (shown in Fig. 7) to place the tea into the tea bag and then add the
appropriate water to the level between MIN and MAX shown by the kettle water
gauge.
2.
After adding water, place the lid properly; lift up the tea bag (Fig. 8) after covering the
lid and then place the kettle on the base; insert the power plug into the corresponding
power socket and then the buzzer will beep twice and all indicators is on for one
second, so the kettle is at the standby state if no any other operation.
3.
The corresponding indicator will be on if the heating temperature is set, so the
heating will start if the heating button presses. The indicator will flash, the buzzer will
beep twice and the temperature indicator will be on if up to the setting temperature,
so the kettle is at the standby state if no any other operation for one
minute.
4.
Press the insulation button twice to start and press it again to cancel. Only the
80℃, and 90℃ can be selected for insulation rather than 100℃. If the insulation
function has been selected, this function will be canceled if the temperature is set to
100°C.
In case of the insulation function selected, if the heating button can not be pressed within
one minute, the insulation function will be canceled to enter into the standby mode.
In case of the insulation function selected, if the heating button is pressed within
one minute, the insulation timing of 30 minutes will count down.
5.
In the heating process, if the temperature indicator flashes, there indicates the setting
heat temperature; if this indicator is on, the water temperature has been up to or
above this setting value;
6.
Others
If the insulation function has been not selected, the kettle will be lifted up from the base to
selection button; 10 - Insulation button; 11 - Heating / Stop
Fig. 5
70℃,
Publicité
