Computer Setup - Alesis M1Active 330 USB Guide D'utilisation

Operation

Computer Setup

The M1Active 330 USB monitors are plug-and-play, so there is no special driver installation necessary. Simply
power on the monitors, connect them to your computer's USB port and all of the necessary drivers will be
automatically installed. To enable your M1Active 330 USB monitors to receive audio from your computer, follow the
instructions below for your computer's operating system.
Note: If you have other USB audio devices connected to your computer, which may have identical names, you may
need to try selecting each one until the M1Active 330 USB monitors are recognized.
Windows XP:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to Start Menu > Control Panel > Sounds and Audio Devices.
3. Click the Audio tab.
4. Under Sound Playback, select USB PnP Audio Device as the default device.
5. Click OK.
Windows Vista:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to Start Menu > Control Panel > Sound. (If you don't see Sound, select Switch to Classic View, and the
Sound control panel should become available.)
3. Click the Playback tab and select USB PnP Audio Device as the default device.
4. Click OK.
Windows 7:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to Start Menu > Control Panel > Hardware and Sound > Sound.
3. Click the Playback tab and select USB PnP Audio Device as the default device.
4. Click OK to close the Sound control panel.
Windows 8:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to the Start Menu, click the lower-left corner of the screen to go to the Desktop.
3. In the Taskbar, locate the Volume Control "speaker" icon. Right-click the speaker and select Playback
Devices.
4. In the Sound control panel select the Playback tab and select USB PnP Audio Device as the default device.
5. Click OK to close the Sound control panel.
Windows 10:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to Start Menu > Control Panel > Sound.
3. Click the Playback tab and select USB Audio Codec as the default device.
4. Click OK to close the Sound control panel.
macOS:
1. Use the included USB cable to connect the left monitor to your computer, and power it on.
2. Go to Applications > Utilities > Audio MIDI Setup.
3. In the Audio Devices window, select USB PnP Audio Device in the left column.
4. Right-click USB PnP Audio Device, and select Use this device for sound output.
5. Quit Audio MIDI Setup.
5