Futurelight PHS-200 Mode D'emploi page 44

Masquer les pouces Voir aussi pour PHS-200:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- Lamp on/off
With this function you can switch the lamp on or off via the Control Board.
Select "OPEN" by pressing [UP] button.
Press [ENTER], the display shows"ON" or "OFF".
Press [UP] to select "ON" if you wish to switch on the lamp or "OFF" if you wish to switch off the lamp.
Press [ENTER] to confirm.
Press [EXIT/DN] in order to return to the main menu.
- Lamp on/off via external controller
With this function you can switch the lamp on or off via an external controller.
Select "ONLI" by pressing [UP] button.
Press [ENTER], the display shows"ON" or "OFF".
Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
Press [ENTER] to confirm.
Press [EXIT/DN] in order to return to the main menu.
- Delay lamp on
With this function you can delay the lamp ignition.
Select "DELA" by pressing [UP] button.
Press [ENTER] to confirm; the display shows "D-00". In this setting, the lamp will be ignited
immediately.
Press [UP] to select the desired delay between "00" and "FF" minutes. If you select "D-03" the lamp
will be ignited after 3 minutes.
Press [ENTER] to confirm.
Press [EXIT/DN] in order to return to the main menu.
- Main menu 2
RPan
rTIl
ON-OFF ON-OFF
Press [ENTER] for 3 seconds to enter the main menu (display flashing).
Press [UP] to select "SET".
rpan
- Pan Reverse
With this function you can reverse the Pan-movement.
Select "rPAN" by pressing [UP] button.
Press [ENTER], the display shows"ON" or "OFF".
Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
Press [ENTER] or [EXIT/DN] to exit.
rtil
- Tilt Reverse
With this function you can reverse the Tilt-movement.
Select "rTIL" by pressing [UP] button.
Press [ENTER], the display shows"ON" or "OFF".
Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
Press [ENTER] or [EXIT/DN] to exit.
Rest
- Reset
With this function you can Reset the device via the Control Board.
Select "rEST" by pressing [UP] button.
Press [ENTER], the display shows"ON" or "OFF".
Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
Press [ENTER] or [EXIT/DN] to exit.
set
REST
LODA
ON-OFF ON-OFF
44/95
ver
v-1.0
00025926.DOC, Version 1.5

Publicité

Table des Matières
loading

Table des Matières