Assembly And Use - Reliable ARIA 100SP Guide D'utilisation

ASSEMBLY AND USE

1. Set press on a flat, level surface.
Warning: The automatic vacuum suction will force the air through the ironing
board and out the back of the press leaving your surface area moist and wet. It
is recommended that you place the press on a surface that will not be affected
by moisture. For example, avoid using the press on wood or laminate surfaces
where the steam and moisture may damage the finish.
NOTE: It is recommended to use a pressing stand when using your steam
press.
2. Gently press the handle (I) down, turn locking knob (B) to "unlock" position,
then lift the handle (I) to open the press. The press will automatically stay in a
lifted position.
3. Before plugging in the press, fill the water tank (N) using the water container
(O) provided. Slide the water tank (N) forward and pour the water into the
tank. When finished, slide the tank back into place. Water is only necessary
when using the steam burst button (J).
NOTE: When filling the water tank, distilled water is preferred, but not
required.
NOTE: The water tank is not removable. It is designed to store any left over
water from use. Do not attempt to force it free.
4. Plug in and press the power on/off button (E) located on the LED digital touch
screen control panel. A power on indicator light (H) will appear. Be sure that
the pressing plate (K) is in an open position when the unit is initially turned
on.
5. Use the fabric temperature selection arrows (A) to choose the fabric setting.
It may take a few minutes to reach the chosen temperature when decreasing
or increasing settings.
NOTE: It takes approximately 12 minutes for the press to reach the linen
temperature.
06