Installation; Installing The Product; Power Supply - Gamko FK Mode D'emploi

Hint! Never install the refrigerator next to a heat source!
Place the product on a smooth surface.
1. Slide the supports (1) in the bottom of
the product.
2. Make sure the product is standing level
using a spirit level.
3. Tighten the supports (1) by inserting the
6mm socket-head screw wrench in the
holes provided (2), until the product is
level.
4. For a closed segment tighten the bolts
under the cabinet
supports (1) with a spanner.
5. Cover the holes at the inside of the
cabinet (2) with the supplied plugs (4)
• The socket should be within easy reach of the cabinet.
• Check for the correct power supply, referred to the information on the type plate.
• Ensure that the plug lead cannot be trapped or snagged.
• If necessary the plug lead can be extended by a qualified electrician.
• We do not recommend the use of an extension lead.
Fluctuations in the power supply can cause damage, which causes the cabinet
to switch off. Gamko cannot be held responsible for any consequential
damage.
User Manual
4

Installation

4.1

Installing the product

(3) holding
4.2

Power supply

the
27