Assembly Of The Smoke Dome And The Flue Collar; Assembly The Inner-Plate - Dovre 1900GL Installation Et Mode D'emploi

3.2.2. Assembly of the smoke dome and of the flue
collar
The smoke dome must be fixed to the top of the device
and attached by means of the clamps supplied. Assure
proper sealing by means of the kit or paste supplied.
It is recommended to install the smoke dome with its
exhaust backwards. In case of proper draft, it may be
turned up to 90° to the left or to the right if required for
installation. In case of lower draft, an angle of maxi-
mum 60° is recommended.
The flue collar can be installed either horizontally or
vertically. Fix the flue collar on the smoke dome with 2
bolts M6x30, 2 nuts M6, and 4 collars Ø6xØ12. Assure proper sealing with kit or
paste.

3.2.3. Assembly the inner-plate

34
1900 03.27831.100