Publicité
12 von 25
Risk of injury due to excessive physical strain
WARNING
Risk of injury due to excessive physical strain.
Spinal injuries.
The relation of the weight of the machine to the physical strength of the technician
A
must be taken into account. For machine weight details, see the operating
instructions.
Stand preparation
A
Use two 6 x 12 screws to attach each of the clamping plates to the rear of the stand; see Fig. 1.
The arrow embossed on the top of the stand points to the front; see Fig. 1.
A
Level the stand on the floor.
A
Mark the hole positions.
A
Drill 12mm dia. holes in the marked positions approx. 65mm deep.
A
Insert plugs (5) in the holes; see Fig. 2.
A
Level the stand using the provided washers (4); see Fig. 2.
A
Fasten the stand to the floor using the hex-head wood screws (1), 8.4 washers (2) and 15 x 44 x 3 washers (3); see
Fig. 2.
Installing a washer on the stand
A
Install the clamps on the stand and fasten them in the appropriate holes (1); see Fig. 3.
A
Secure each clamp to the stand with one M6 x 30 bolt (1), two galvanized B6.4 washers (2) and an M6 nut (3). Do not
tighten the nuts yet; see Fig. 4.
A
Unscrew the washing-machine feet by at least 5mm.
A
Place the washing machine on the stand and slide its rear feet into the clamping plates.
A
Level the washing machine on the stand.
A
Use the clamps to secure the washing machine to the front feet; see Fig. 4.
A
Install a second M6 nut (4) on each of the feet to counter the first nut; see Fig. 4.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten; see Fig. 5.
Installing a dryer on the stand
A
Unscrew the dryer feet by at least 5mm.
A
Place the dryer on the stand and slide its rear feet into the clamping plates.
A
Level the dryer on the stand.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 6.
Installing the stand panels
A
Use four M4x25 screws to attach each of the two side panels; see Fig. 7.
A
Use four M4x25 screws to attach the front panel; see Fig. 7.
en-US
es
20.01.2020
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11313351
Publicité
