Denon Professional DN-300UI Guide D'utilisation page 7

Date & Time
Select this option to configure the Date & Time settings.
• Set Date and Time: Select this to edit the Date and Time settings. Choose Manual Setup
to enter the date and time manually, or select Auto Detect to have DN-300UI detect the
date and time based on your network connection.
• Set Time Format: Select this to set the time format to 12 Hour or 24 Hour.
• Set Date Format: Select this to set the date format to YYYY/MM/DD, DD/MM/YYYY, or
MM/DD/YYYY.
Alarm
Select this option to set or edit an alarm.
• Alarm 1 and Alarm 2: Select these options to Turn On or Turn Off the two alarms.
o Repeat: Sets when the alarm is active. Choose Everyday, Once, or the Day of Week.
o Time: Sets what time the alarm will ring. Choose HH, MM, and AM/PM.
o Sound: Sets what sound will be used for the alarm. Choose Beep, Melody, Internet
Radio, FM, or USB.
• NAP Alarm: Select this to choose the default snooze time for when the alarm rings.
Choose Turn Off, 5 Minutes, 10 Minutes, 20 Minutes, 30 Minutes, 60 Minutes, 90
Minutes, or 120 Minutes.
• Alarm Volume: Sets the volume of the alarm.
Timer
Select this option to set a timer. Use the Navigation buttons to set the desired time.
Language
Select this option to set the operating language.
Dimmer
Select this option to set the brightness levels of the display. Select Power Saving to set the
brightness level when the Dimmer is enabled or the unit is in standby mode. Select Turn On
to set the brightness level when the Dimmer is disabled and the unit is on.
Display
Select this option to set the Display appearance to Color or Monochrome.
Power Management
Select this option to set an amount of time after which the unit will go into standby mode if
there is no activity. Choose Turn Off, 5 Minutes, 15 Minutes, or 30 Minutes.
Sleep Timer
Select this option to set a Sleep Timer to put the unit in standby mode. Choose 15 Minutes,
30 Minutes, 45 Minutes, 60 Minutes, 90 Minutes, 120 Minutes, 150 Minutes, or 180
Minutes.
Buffer
Select this option to set the preferred amount of buffer time. Choose 2 Seconds, 4 Seconds,
or 8 Seconds.
7