Brutus 61024 Manuel D'utilisation page 10

Adjustable Cutting Table Extension
The adjustable cutting extension table is for the support of large format tiles. Users
could adjust front and side extension to desired dimension. (See Diagram 10)
Cutting Tile and Stone
WARNING!
1. Before performing any cuts, check and ensure that the lowest point of the Blade is no
more than 3/16 in. (5 mm) below the table top. (See Diagram 11)
2. Move the Motor Head Height Adjustment Lever upward (See Diagram 12), to adjust
the head to a proper height below the table. Then lock the lever in the down position.
Straight Cuts
1. Adjust the 45/90 degree rip guide to 90 degree and position it the desired distance
from the blade. (See Diagram 13)
2. Lean the cutting material against the rip guide and back measurement rail.
3. Loosen the slide tube locking knob. (See Diagram 14)
4. Make a straight cut by pushing the cutting table toward the cutting head.
(See Diagram 13)
Diagonal Cuts
1. Adjust the 45/90 degree rip guide to 45 degree and position it the desired distance
from the blade.
2. Position the cutting material against the rip guide and back measurement rail.
3. Loosen the slide tube locking knob. (See Diagram 14)
4. Make a diagonal cut by pushing the cutting table toward the cutting head.
(See Diagram 15)
Turn off the power before adjusting the tile saw
CAUTION!
motor head for plunge cuts or bevel cuts.
Plunge Cuts
1. Turn off the power.
2. Position the cutting material against the rip guide and back measurement rail.
3. Loosen the slide tube locking knob. (See Diagram 14)
4. Loosen the Motor Head Adjustment lever on the spring (See diagram 16) support, to
release the cutting head.
5. Bring motor head to the highest position.
6. Push the cutting table to the desired position where the blade is over the tile at the
point you want to start the cut-out.
7. Tighten the slide tube locking knob to a fixed table position.
8. Turn the saw on.
9. Slowly push the blade down into the tile to achieve the plunge internal cut you
desire. (See diagram 17)
10. After each cut, turn the motor off and turn the position of the tile to achieve
rectangle or square cut-outs.
Bevel / Miter Cuts
WARNING!
Step 1: Turn off the power.
Step 2: Position the cutting table in its farthest back position and lock with slide tube
locking knob.
Step 3: Loosen the Bevel Adjustable Knob on the Bevel Support Arm (See Diagram 18),
found at the back of the motor head, to adjust the guide by tilting the head
(See Diagram 19) to 22.5° or 45°angles. (Make sure the blade aligns with the
angle slot provided on the cutting table.)
The saw is adjustable to three positions (0°, 22.5 °or 45°).
Any other bevel cut will damage the work table.
- 10 -
Diagram 12
Motor head height
adjustment
Diagram 13
RIP GUIDE
Diagram 14
Diagram 15
RIP GUIDE
Diagram 16
lever