Assembly & Set Up; Stand Setup - Brutus 61024 Manuel D'utilisation

ASSEMBLY & SET UP
CAUTION!
A. Stand Setup
1. The Saw and Stand are ready to use. Simply unfold it as shown below.
2. Place the saw frame on the stand and tighten the stand knobs for safety. (See
Diagram 1) You may need to move or remove water tray to easily secure safety
knobs to stand frame.
B. Installing the Motor assembly
Step 1: Install the Motor Frame Assembly into the Motor Support Arm. (See Diagram 2)
Step 2: Pre-fix the Motor frame red locking knob into the hole provided, as shown. This
knob is used to also fine-tune the alignment of the motor frame assembly.
Step 3: Remove rubber cap to expose hex nuts. Firmly drive the three HEX bolts into
the Motor Support Arm with Allen Key provided and secure the Motor frame
locking knob.
Step 4: Place rubber cap back over hex nuts.
C. Installing the 4 in. Caster and Cord Collecting Hanger
1. Installing Upper Casters : Secure the 4 in. Casters at the two ends of the Base Frame
with HEX bolts & Nuts, as shown. (See Diagram 3)
2. Installing Cord Collecting Hanger/ Tool Caddy : Secure the Hanger onto the Motor
Support Arm with 2 bolts. (See Diagram 4) Place 2 wrenches in hanger and place
Allen Key in opening provided.
D. Diamond Blade Installation
Step 1: When installing the blade, separate the two water
feed hoses inside the blade guard to allow the blade
to sit between them (see diagrams at right).
Step 2: Lift the blade guard and lock in place with the knob
holding the blade guard.
Step 3: Hold the blade lock nut with the provided 23 mm wrench and also hold the blade
shaft with the other provided 10 mm wrench. At the same time, please move
Diagram 3
The following is step-by-step installation and operation instruction manual.
Please read the information thoroughly prior to using your tile saw.
Diagram 4
Diagram 5
- 8 -
Diagram 1
Diagram 2
Diagram 6