Diamond Blades; Do's & Do Not's For Diamond Blades; Troubleshooting - Brutus 61024 Manuel D'utilisation

DIAMOND BLADES

1. Use only 10 in. wet continuous rim diamond blade with this saw.
2. Arbor size is 5/8 in. Please choose the right size to fit the inner flange.
3. Do not use wood sawing blade, or other blades not suitable for ceramic, porcelain or
stone. Severe body injury or the saw damage may occur.
DO & DON'TS For Diamond Blades
DO'S:
1. Inspect blades daily for cracks or uneven wear. Discard cracked, chipped
or bent blades!
2. Always use manufacturers' recommendation for matching the right blade with the
right material being cut.
3. Inspect the arbor shaft for uneven wear before mounting the blade.
4. Always use blades with the correct arbor size on a compatible arbor shaft (5/8 in.).
5. Ensure the blade is mounted with the rotation arrow in the proper direction and is
securely tightened with a wrench.
6. Always wear the proper safety equipment at all times when operating the saw.
7. Always have a continuous flow of water on both sides of the blade before cutting
any material.
DONT'S:
1. Do not operate the saw without all safety guards in position.
2. Do not operate the saw with blades larger or smaller than 10 in. (254 mm).
3. Do not cut dry with blades marked "Use Wet".
4. Do not exceed maximum RPM recommended by the blade manufacturer.
5. Do not force the material into the blade. Let the blade cut at its own speed.
6. Do not cut material not recommended by the blade manufacturer.

TROUBLESHOOTING

OVERHEATING OF SAW:
A. Turn saw off and let it rest until motor is cool to the touch.
B. Check and clean the ventilation slots, removing blockage and dirt.
THE SAW DOES NOT START:
A. Confirm power cord is properly plugged in.
B. Check power source voltage is 120V from outlet.
C. Switch is at the "ON" position.
Water is not flowing through the water pump:
A. Make sure water in tray is high enough to clear the intake nozzle.
B. Make certain the water valve connecting the pump to the tubing is in
the "ON" position.
C. Check water hose for connection or clogs.
D. Confirm power cord is properly plugged in.
E. Check for excess debris on intake filter.
CUTTING TABLE IS NOT SLIDING SMOOTHLY:
A. Thoroughly clean Guide Rails.
If problem continues, contact:
Q.E.P. Customer Service at 1-800-777-8665
- 12 -
Diagram 22
Diagram 23