Gaggenau VI 491 610 Notice De Montage page 8

When combining several appliances with or without
appliance cover, you can use the appliance extensions
VA 450 110/-400/-600/-800/-900 (depending on
appliance width) to balance out dimension differences.
Hole for control knobs
The built-in control console can be integrated into the
lower cabinet at drawer level. Panel thickness:
(16 - 26 mm)
1 If front panel thickness is greater than 1" (26 mm):
Mill out front panel on rear side to the point that the
thickness doesn't exceed 1" (26 mm). Adjust the
measurements of the milled-out section to fit the
holding plate.
8
For flush mounting:
2 According to the figure, create the drill holes Ø 1
" (35 mm) for fixing in place the control knobs in
8
the front side of the lower cabinet. A drilling
template is included for precise positioning of the
drill holes.
5 / " - 1"
8
For flush mounting:
/
3