Adjustment Elements; Adjusting The Working Depth - Stihl AHK 701 Manuel D'utilisation

● Loosen both lock nuts (2). Loosen
locating screw (3). Loosen adjustment
screw (1) by turning in an anti-
clockwise direction. Then tighten
locating screw (3) by hand until the
ridger is secure, tighten both lock
nuts (2) again.
Increasing the operating angle (B):
● Loosen both lock nuts (2). Loosen
locating screw (3) and tighten
adjustment screw (1) by turning in a
clockwise direction. Then tighten
locating screw (3) by hand until the
ridger is secure, tighten both lock
nuts (2) again.
8.2 Adjusting the working width
The side wings (1) of the ridger can
be adjusted to change the working
width (C) of the ridger.
Adjusting the working width (C):
● Lift retainers (2) and fit in one of the
holes on wings (1).

9. Adjustment elements

AHK 702

9.1 Adjusting the working depth

The ridger can be installed higher or
lower on the tiller as required.
Adjusting the working depth:
● Loosen tommy screw (1) and set
ridger (2) to the required height. Then
tighten the tommy screw by hand until
the ridger is secure.
14
9
10
0478 906 9906 A - EN