Panasonic ER-GB37 Consignes D'utilisation page 12

How to use
• Make sure that the main body is turned off.
• Apply the oil to the blade before and after each use.
(See page 15.)
• The appliance may not operate in an ambient
temperature lower than approximately 0 °C.
• Check that the blades are not damaged or deformed
before use.
• Before trimming, comb your moustache with a comb.
• Please clean the appliance after each use.
(See pages 14 and 15.)
Dry trimming
► Trimming with the comb attachment
• Do not use with shaving foam applied or when the
beard is wet.
1
1
Mount the comb attachment and adjust the dial.
(See page 11.)
2
2
Slide the power switch to the " "
position to turn on the trimmer.
12
PB017461 - ER-GB37 _(01GB)_05-07-19.indd 12
3
3
Hold the trimmer with the power
switch facing upward, and cut the
beard by moving the trimmer back
against the flow of the beard.
• Hair trimmings may collect inside
the attachment when a large
volume of beard is cut, so discard
hair trimmings after each use.
► Trimming with the comb attachment
Shaping your moustache
■ Above the lips
Place the trimmer at a right angle
to your skin with the power switch
facing downward and trim around
your moustache.
To round out the shape, trim
around your moustache by holding
the main body sideways.
■ Trimming the edge of beard
Cut your beard gradually with
the power switch facing outward,
taking care not to cut too much.
2019/5/10 15:40:50