Removing A Sensor; Adding Remote Panels; Using The Service Menu - Honeywell 301 Serie Mode D'emploi

Removing a Sensor

This menu lets users remove a sensor from the 301EM.
Scroll to the Disable? menu option and press enter to select.
•

Adding Remote Panels

The Set #RP menu lets users add up to 10 remote panels (301EMRP) to the 301EM's network.
Scroll to the Set #RP menu option and press enter to select.
•
In the Set #RP screen, use the arrows to scroll the desired number (since you can add up to ten re-
•
mote panels you can select a number between 1 and 10) and press enter to select.
Once entered the 301EM's network, the remote panels will display or announce the status of the 301EM's sen-
sors.

Using the Service Menu

The Service menu allows users to configure several service related options, such as when and how to activate
service alarms. Service alarms are used to signal when a sensor needs to be replaced or calibrated.
This menu contains two options: Set Act and Set Time.
The Set Act menu lets users select the action that will be taken. Available options are: Fault, OFF or Visual
Fault: A service alarm will be activated whenever there is a fault status
OFF: No service alarm will be triggered at any time (factory default setting)
Visual: Only a visual service alarm will be activated
The Set Time menu lets users configure a specific deadline at which a service alarm will be activated.
Use the arrows to scroll between 12 to 24 months to trigger a service alarm after the specified number of
months in service. Select the Reset option to turn off the Service alarm for a period of 100 days (after the alarm
was triggered).
90
Sensor
Disable?
Menu
Set #RP
Set #RP
0 EMRP
Menu
Service
Service
Set Act