Adjusting The Speaker Output Levels; Before You Begin; Using The Test Tone (Test Dolby Sur.) - Yamaha RX-V620 Mode D'emploi

ADJUSTING THE SPEAKER OUTPUT LEVELS

This section explains how to adjust the speaker output
levels by using the test tone generator. When this
adjustment is made, the output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound
field processor, the Dolby Pro Logic decoder, Dolby
Digital decoder and DTS decoder.
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.

Before You Begin

1
D I G I T A L
SURROUND
STANDBY
/ON
BASS BASS TREBLE SPEAKERS
EXTENSION DSP
A B
EFFECT PROGRAM
ON OFF – + – + ON OFF
PHONES S VIDEO
SILENT
3 3 2
1
Press STANDBY/ON to
turn on the power. Turn on
the video monitor.
2
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
3
Set BASS and TREBLE on the front panel to
the center position and set BASS
EXTENSION to OFF.
BASS
EXTENSION
ON OFF
Set to OFF.
VOLUME
D I G I T A L
INPUT MODE 6CH INPUT
PRESET INPUT
TUNING
/TUNING FM/AM MEMORY MODE
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
VIDEO L AUDIO R OPTICAL
VIDEO AUX
STANDBY
/ON
SPEAKERS
A B
ON OFF
BASS TREBLE
+ +
– –
Using the Test Tone (TEST DOLBY
SUR.)
The adjustment of each speaker output level should be
made at your listening position with the remote control.
1
A/B/C/D/E
1
Set the selector dial to the
AMP/TUN (or DSP/TUN)
position.
2
Press TEST to output the test tone.
3
Adjust the volume so you can hear the test
tone.
The test tone is heard from the left main speaker,
center speaker, right main speaker, right rear speaker
and left rear speaker in order. The tone is produced
for 2.5 seconds each time.
(TEST LEFT)
LEFT SURROUND
(TEST L SUR.)
2,6
A/B/C/D/E
5
4
3
LEFT RIGHT
(TEST RIGHT)
CENTER
(TEST CENTER)
RIGHT SURROUND
(TEST R SUR.)
21