Graco LineLazer GM 3500 Manuel D'instructions page 86

Clutch Rotor/Field Adjustment
WARNING
To reduce the risk of serious injury whenever you
are instructed to relieve pressure, always follow the
Pressure Relief Procedure on page 7.
Tool List
3/8 in. hex key wrench
1/4 in. hex key wrench
Cleaning solvent
55b
Fig. 34
70
A
Adjustment
See Fig. 34.
1. Remove any residue from the clutch housing (61).
2. Seat the field (70) squarely in the clutch housing.
Do not tighten the four field set screws (62).
3. Install the rotor (4b). Set the clearance between
the outside diameter of the rotor and the inside
diameter of the field with the four 0.010 in. (0.25
mm) gages (A), supplied. Place the gauges 90
apart.
4. Adjust the position of the field with the four field set
screws to maintain 0.010 in. (0.25 mm) minimum
clearance all the way around the rotor.
5. Tighten the four field set screws, evenly, to 27 in-lb
(3.1 N.m). Remove the four gauges.
62
61
05701