Graco LineLazer GM 3500 Manuel D'instructions page 75

Trigger Cable & Dual Gun
Trigger Cable Tension Adjustment
1. Relieve pressure. See page 7.
2. Be sure the gun is properly mounted in the holder as
instructed on page 20.
3. Pull the actuator lever (94) forward and hold it. Lift up
on the gun trigger (A) until there is slight resistance.
Visually check to see if there is about 1/32 to 1/16 in.
(1–2 mm) gap between the trigger lever (B) and
where the gun trigger touches the bar.
4. To adjust the tension, loosen the screw (C) in the
block (48). Slide the block forward to increase the
gap and backward to decrease the gap. Tighten the
screw.
5. Recheck the gap and adjust as needed.
CAUTION
Do not allow the cable (402) to rub against the
outside edges of the slot (H) in the block (48), to
prevent premature wear of the cable. Rotate the
block slightly to eliminate rubbing. See Fig. 21
DETAIL A.
Selector Operation
See Fig. 21
FORWARD
94
A
B
DETAIL A
Be sure end jacket of cable
seats here. keep jacket and
seat clean
48
Fig. 21
1 or 402
48
C
45
1/32 – 1/16"
(1–2 mm)
0023
1 or 402
45
0024